Tait TB9100, Installation And Operation Manual

Page: 13 / 144

TB9100 Installation and Operation Manual Description 13
© Tait Electronics Limited May 2006
Subrack
The TB9100 4U subrack is made of passivated steel and is designed to fit
into a standard 19 inch rack or cabinet.
1.3 Frequency Bands and Sub-bands
Much of the circuitry in the TB9100 base station is common to both
frequency bands, and is therefore covered by a single description in this
manual. Where the circuitry differs between VHF and UHF, separate
descriptions are provided for each frequency band. In some cases the
descriptions refer to specific VHF or UHF bands or sub-bands, and these are
identified with the letters listed in the following table.
Frequency
Identification
Frequency Band and Sub-band
VH
F
B band B1 = 136MHz to 174MHz
B2 = 136MHz to 156MHz
B3 = 148MHz to 174MHz
UHF
H band H0 = 400MHz to 520MHz
H1 = 400MHz to 440MHz
H2 = 440MHz to 480MHz
H3 = 470MHz to 520MHz
K band K4 = 762MHz to 870MHz
a
a. The actual frequency coverage in this band is:
Transmit: 762MHz to 776MHz, and 850MHz to 870MHz
Receive: 792MHz to 824MHz