24
Installation Guidelines
MBZ-00001-01
November 2004
Copyright © 2004 Tait Electronics Ltd
3.3.1
DC Output Terminal Block
The DC Output Terminal block on the rear of the T809-10 is a Phoenix Contact HDFKV
10. This is a screw-type terminal connector that uses a cage mechanism to clamp the
conductor(s).
When installing:
• Use a stripping length of 11mm.
• Do not twist the strands of the conductor prior to clamping.
• Securely fasten the conductor(s) with a tightening torque of 1.5Nm (recom-
mended minimum).
• Observe maximum wire cross-sections as outlined in the table below.
3.3.2
Auxiliary Inputs Connector
The 9-way D-range connector on the T809-10 rear panel (auxiliary inputs) provides
access to the remote control and remote sense functions of the power supply. For con-
nection details, refer to Sections 3.5 (Remote Sense) and 3.6 (Remote Control).
Conductor Type
Number of
Conductors
Maximum Cross-section
Flexible (stranded)
1
10mm
2
(AWG = 6)
2
†
† These conductors use the same cross-section
4mm
2
(each)
Solid
1
16mm
2
2
4mm (each)
Flexible with ferrule and
plastic sleeve
1
10mm
2
2
2.5mm
2
Flexible with ferrule
without plastic sleeve
1
10mm
2
Flexible with twin ferrule
and plastic sleeve
2
6mm
2
Summary of Contents for T809-10
Page 12: ...12 General Information MBZ 00001 01 November 2004 Copyright 2004 Tait Electronics Ltd ...
Page 36: ...36 Troubleshooting MBZ 00001 01 November 2004 Copyright 2004 Tait Electronics Ltd ...
Page 41: ...MBZ 00001 01 Service Information 41 Copyright 2004 Tait Electronics Ltd November 2004 ...