Tait T2020 Series II, Operator'S Manual, Page: 28 / 35

26
STAT
Ch
Fn
α
T2000
II
3. On entry into the setup process, the display flashes the last selected diversion call type, either
Selcall or DTMF. Use the Up and Down keys to toggle between the two options. Note that if the
DTMF option has not been fitted on the radio, the DTMF call type will not be an option.
4. Press the Enter key to confirm the call type selected, and the last selected sequence is displayed,
if still valid. If the last selected sequence is no longer valid, the default sequence is displayed.
5. If another sequence is required, use the numeric keypad to enter the new diversion sequence.
Note that the correct sequence length must be entered (consult your Tait dealer for more informa-
tion on this).
6. Press the Enter key to confirm the diversion sequence and to put the radio into Call Diversion
mode.
Exiting Call Diversion Mode
At any stage of the call diversion setup process, any mode key-press initialises that mode, and there-
fore takes the radio out of the Call Diversion Setup process or Call Diversion mode. This includes the
Function (
Fn
) key.
Receiving a Call During Call Diversion
When a standard incoming call is received by the radio in Call Diversion mode, the programmed auto-
acknowledge sequence is transmitted, as for a normal call. However the programmed diversion status
is transmitted instead of the normal acknowledge status, to inform the caller that the call has been
diverted.
The radio then switches to the programmed call diversion channel and transmits the sequence that has
been set up for the call diversion, without indicating to the user that an incoming call has been received
(no ringing). After executing the diversion transmission, the radio reverts to the channel it was on prior
to the call diversion.