Taga Harmony TTA-500, Instruction Manual, Page: 10 / 16

10
Note! Never perform this operation while the amplifier is turned on [turn off the amplifier
and remove the Power Cable] – it can damage this amplifier or speakers. This may
void your warranty.
Note! Make sure to select the same mode (Triode or Pentode) for both channels.
4. Using speaker cables (not supplied with this product) connect your speakers to the
SPEAKERS OUT connectors located on the rear of the amplifier (check “Hooking
Up Speaker Cables” for more details).
5. If you want to play music from analog audio source devices (CD player, FM tuner,
TV tuner etc.) : using RCA interconnect cables (not supplied with this product) connect
them to the analog inputs (CD, LINE, AUX).
6. Preamplifier Input (HT PRE IN) : this amplifier is equipped with the preamplifier input.
Using an RCA interconnect cable (not supplied with this product) you can connect to
it external devices equipped in the preamplifier output (PRE OUT) [AV Receiver, AV
Amplifier, AV Processor etc.] and use this amplifier as a stereo power amplifier [for
instance in Home Theatre systems].
The HT PRE IN level is not variable controlled according to the Volume Regulator – an
external device has to be with its own volume control.
7. Your amplifier is ready for operation.
Note! Avoid to short-circuit of cables – it can damage this amplifier or speakers. This
may void your warranty.
Note! Only speakers within range of impedance 4 - 8ohm can be connected.
Connecting speakers outside this range can damage this amplifier and/or speakers.
This may void your warranty.
!
Important Note!
Never connect directly sources without the preamplifier output (for
instance CD/DVD/Blu-ray Players, DA Converters, Music Streamers
etc.) to the HT PRE IN input – it can damage this amplifier or
speakers. This may void your warranty.