Taga Harmony TS Series, Instruction Manual

Page: 7 / 12

7
Operation
1. Make sure your audio source (amplifier, receiver etc.) is switched off.
2. Make sure that the volume regulator on your audio source is set to minimum.
3. Switch OFF all the Zones on the Speaker Selector (Zone Selectors in the OFF
position).
4. Switch ON the Protecting Circut (the „PROTECT” switch is in the ON position).
5. Using speaker cables (not supplied with this product) connect your audio source to
the amplifier INPUT terminals located on the rear of the Speaker Selector.
6. Using speaker cables (not supplied with this product) connect your speakers to the
required speakers OUTPUT terminals located on the rear of the Speaker Selector.
7. Switch on your audio source and start playback on a connected device.
8. Select active Zones (press ON Zone Selector switches for the corresponding
zones), to which you want to transmit an audio signal from your audio source.
9. Regulate volume on your audio source to adjust level of sound in in the active
Zones.
Zone Selectors:
ON: Press down one of there switches (the switch in the ON down position) to
transmit an audio signal from your amplifier (receiver) to the speakers in the
corresponding zone (room).
OFF:
Press it again to switch off the transmission (the swiitch in the top position).
PROTECT Protecting Circuit Switch:
This model has manually activated impedance protection circuit.
In the ON position regardless of the number and nominal impedance of the
connected speakers it prevents of impedance drop below an unsafe level of 5 ohm,
what can cause damages to your audio source (amplifier, receiver).
High volume levels can damage your amplifier (receiver),
this products and / or speakers. This may void your warranty.
The speaker selector accepts speakers with the impedance
of minimum 4Ω or higher.
Connecting speakers with lower impedance may damage this unit,
audio source and / or speakers. This may void your warranty.
The total RMS power of all connected speakers should not exceed
the nominal RMS power of the audio source. Unless not all zones
are used at the same time - in such a case the total RMS power
of all speakers connected to the active zones should not exceed
the nominal RMS power of the audio source.
Failure to follow the above recommendations may damage this unit,
audio source and / or speakers.
This may void your warranty.