11
6. Preamplifier Output (PRE OUT) : this amplifier is equipped with a preamplifier
output. Using an RCA interconnect cable (not supplied with this product) you
can connect to it external equipment (power amplifier, powered speakers, active
subwoofer etc.).
The PRE OUT level is variable controlled according to the Volume Regulator.
All sound regulations (Loudness / Bass / Treble) will affect the sound transmitted to
the PRE OUT.
7. If you want to listen to music via headphones: connect the headphones to the
Headphones output (check “Headphones connection” for more details).
8. If you want to stream music via
Bluetooth
®
from compatible devices check
“
Bluetooth
®
Connection” for more details.
9. Your amplifier is ready for operation.
Operation
1. Plug the Power Cable to the amplifier and into the electrical outlet.
2. Turn on the amplifier – press the Power Switch (the Power Switch
).
The status LED located on the Volume Regulator should turn red in a few seconds.
If it does not, it means that the amplifier is working in abnormal condition
(a protection mode) – turn off the power, unplug the Power Cable and check
whether some of the cables are not short circuited. After fixing the cables turn the
amplifier on.
3. By pressing the Input Selector button on the front panel or pressing one of the
input selector buttons on the remote controller, select which audio source you want
to play.
Make sure the audio source is properly connected to the rear panel inputs.
The selected source is indicated by one of LED indicators on the front panel.
4. Turn on your audio source and start playback.
5. Regulate volume on the amplifier to adjust the level of sound.
Note!
Check “Additional Information” for other useful operating instructions.
Headphones connection:
When headphones (not supplied with this product) are plugged to the headphone input
(Phones) the transmission of sound to the speakers and PRE OUT is switched off. The
speakers and PRE OUT are again active after you disconnect the headphones.
The volume of the headphones is regulated by the Volume Regulator (front panel and
remote controller).
All sound regulations (Loudness / Bass / Treble) will affect the sound transmitted to the
headphones.
Hooking up the Amplifier
Only speakers within range of impedance 4 - 8Ω can be connected to
this amplifier. Connecting speakers outside this range can damage this
amplifier and/or speakers. This may void your warranty.
High volume levels can damage this amplifier and/or speakers.
This may void your warranty.
