T200M Series Installation Manual - Aeonix
Phone Hardware Description
31
Positioning and Mounting the Phone
4
Figure 16 Wall-Mounting
Template
5
Make a mark on the wall in each of the template holes as indicated in
.
6
Use a small drill bit (#7, 13/64”, 5mm or smaller) to drill three holes into the
wall for the mounting screws. The hole drilled should be only wide enough to
allow the wall plugs to enter snugly, not loosely.
7
Insert the three wall plugs into the holes.
8
Tighten the three screws into the wall plugs, taking care to leave enough space
to insert the wall mounting holes on the bottom of the phone.
9
Fold the U-type frame such that it is level with the rear of the phone.
10
Connect the PC and LAN cables and the power supply cord, if applicable.
11
Align the holes on the rear panel of the U-type frame with the screws on the
wall, and mount the phone onto the wall.
12
Tighten the screws.
13
Press down the handset latch and connect and position the handset.
This way up
This way up
Summary of Contents for Aeonix T200M Series
