T200M Series Installation Manual - Aeonix
Phone Hardware Description
23
Connecting to the Network (LAN / PC)
4
................................................................................................................
Connecting to the Network (LAN / PC)
Setting the Power over Ethernet (PoE) Switch (
T207M, T208M, T208M/BL
)
Before connecting the cables, verify that the Power over Ethernet (PoE) switch is
switched to the correct setting, if applicable (in some models).
If there is a PoE/Adapter selection switch on the phone, do one of the following:
If the telephone set is to be powered via the LAN, turn the switch to
PoE
.
If the telephone set is to be powered via the AC power adapter, turn the switch
to
Adapter
.
One Internal Switch for PC and Phone
Two RJ-45 connector outlets are located on the bottom of the phone. See
These connectors create an internal bridge for both the IP telephone and the computer.
The phone is connected to the LAN wall connector with the RJ-45 cable provided,
using the LAN connector on the bottom side of the phone. The phone is connected to
the PC with an RJ-45 cable, using the PC connector on the bottom of the phone. See
. The communication protocol for both LAN and PC is 10/100Mbps, half, full
or auto duplex. The recommended setup is 100Mbps, auto duplex.
Figure 8
T207/T208
Bottom, Rear and Side
View
Handset
connection
TEM
connector
Headset
connections
Service port
Do not open
Source
Adapter
PoE
Reset
Wall-mount hole
Service door
Left view
Bottom view
Right view
Product label
Power Source
DC-IN
Adapter
PoE
-
Reset
button
Link/
Activity
green LED
indicators
LAN
PC
Power
adapter
input
Power
source
selector
(available on some phones)
Handset
Summary of Contents for Aeonix T200M Series
