TAD M1000, Owner'S Manual

Page: 10 / 88

10
Connecting your equipment
CAUTION
'
Do not turn on the power switch to the unit or the other components until all connections have been completed.
'
Set the BI-AMP Switch to “Stereo”.
We recommend that you place the speakers at the desired location before performing connections. Use commercially
available speaker cables for connections. When connecting other components, make sure to turn the power off and
unplug the other components before connecting.
INPUT R INPUT L
UNBALANCED BALANCED UNBALANCED BALANCED
SPEAKER R SPEAKER L
ON OFF
AUTO
POWER DOWN
12 V
TRIGGER IN
AC IN
BALANCED
UNBALANCED
BI-AMP
STEREO
BI-AMP
STEREO
BALANCED BALANCED
USB
XLR COAXIAL
AC IN
12 V TRIGGER
IN
1 2 3
4 5
DIGITAL INPUT
R L
LINE 1 BALANCED LINE 2 LINE 4 LINE 3 LINE 1 BALANCED LINE 2 LINE 4 LINE 3
D2
D3
D1
ANALOG INPUT ANALOG OUTPUT ANALOG INPUT ANALOG OUTPUT
OUT
+ - + -
+ - + -
R L
R L
To balance
output
terminal
Speaker
Speaker
To speaker
terminal
To speaker terminal
Pre-Amplifier
Connecting to the Pre-Amplifier
Using a commercially available cable with balanced-type XLR plug, connect the Pre-Amplifier’s balanced output
connectors to this unit’s balanced input connectors. When using an unbalanced connection (RCA pin jack), set the
BALANCED/UNBALANCED input connector selector switch to “UNBALANCED”.
1 2
3
BALANCED
INPUT (BALANCED) terminal
(XLR-3-31 equivalent)
1: Ground
2: Hot
3: Cold
Note
It is recommended to use less than 3 m length of Cable for connecting input terminal and speaker terminal.