TAD DA1000, Owner'S Manual

Page: 11 / 128

11
English
Main unit rear panel
USB XLR COAXIAL OPT
DIGITAL INPUT
XLR COAXIAL 12 V
TRIGGER
IN
D4 D1 D2 D3
BALANCED UNBALANCED
L L R R
AC IN
1 5 2 4 3 6
1 ANALOG OUTPUT connectors
Connect to Pre-Amplifier.
• BALANCED X LR type
•
UNBALANCED RCA type
2 USB port
Use to connect a USB cable to computer.
3 DIGITAL INPUT connectors
Connect to a component equipped with a digital output
connector.
• X
LR (balanced) type (D1)
• COA X IAL type (D 2 , D 3 )
•
OPT (optical) type (D
4
)
4 12 V TRIGGER IN connector
When this connector is connected to another component
equipped with 1 2 V trigger, the connected component can
be used to switch this unit
’
s power ON
/
standby.
Connector:
Ø 3
.
5
mm monaural mini-
j
ack
Operating conditions:
•
During standby mode, when input signal
’
s voltage goes
from L to H (power ON mode).
•
During power ON mode, when input signal
’
s voltage
goes from H to L (standby mode).
When an H signal value is input to the 1
2
V trigger
connector, the unit
’
s power switch cannot be used to
switch the unit to the standby mode.
5 DIGITAL OUTPUT connectors
Connect to a component equipped with a digital input
connector.
• X
LR (balanced) type
• COA X IAL type
6 AC IN connector
Connect the supplied power cord here.