8
3.
The LED should fl ash. If accompanied by
two beeps the V-tail mix function has been
activated. “V-tail” is a mixture of the elevator
and rudder channels. Two servos are used
in the tail; one for each control surface. This
will control the airplane’s “pitch” and “yaw”
axis at the same time. If the elevator and
rudder functions appear reversed at the control surfaces it may be necessary to swap the channel
2 and channel 4 servo plug positions in the receiver. If this is the desired mix function move to the
next section.
4.
To skip the V-tail mix and
instead activate the elevon
(delta wing) mixer, turn the
Tx power switch OFF and
repeat the above procedure.
When the flashing LED is
accompanied by three beeps
the elevon mixer will be active.
“Elevon” is a mixture of the elevator and aileron channels and controls the airplane’s “pitch” and “roll”
axes simultaneously. One servo is used for each control surface. If the elevator and aileron functions
appear reversed at the control surfaces, it may be necessary to swap the channel 1 and channel 2
servos’ plug positions at the receiver.
5.
To cancel all mixes, repeat this procedure again. When the fl ashing LED is accompanied by one beep
all mixes will be off.
RECEIVER (Rx)
Link
Button
Link
LED
Outputs
CH8 Auxiliary
CH7 Auxiliary
CH6 Auxiliary
CH5 Auxiliary
CH4 Rudder
CH3 Throttle (electronic speed control or servo)
CH2 Elevator
CH1 Aileron
BAT Battery
Mount the Rx as specifi ed in the model’s instructions. Wrapping the Rx with foam rubber can help to prevent
damage resulting from vibration but could prevent adequate airfl ow from passing over the Rx. See the
SERVOS AND ACCESSORIES section for additional Tactic receivers.
Left Rudder
ch2
ch4
ch2
ch4
Right Rudder
ch2
ch4
Up Elevator
Elevator
Function
Aileron
Function
RECEIVER and FLIGHT EQUIPMENT INSTALLATION
(if applicable)
