5
BUILT-IN 1S LIPO CHARGER
A 1S LiPo charger is built into the TTX402 transmitter itself. This charger is designed
specifi cally for charging a micro 1S 3.7V LiPo cell having a micro connector. Charge
current is rated at 250mAh, with a maximum charge voltage of 4.20V. Charging will
begin automatically when the battery is connected, and automatically stop when full
charge is detected. It is not recommended to charge a 1S LiPo while fl ying.
1S LiPo Battery
attery
1. Make sure the Tx power switch is in the off position.
2. Looking at the rear of the Tx, slide open the charger door by moving it to the right.
3. Connect the 1S LiPo battery to the socket inside the battery door. When a proper
connection has been made and the battery is being charged, the “CHARGE” LED
will illuminate.
4. When charge is complete the CHARGE LED will turn off.
.
IMPORTANT WARNINGS REGARDING LIPO BATTERY USE!!
NEVER ATTEMPT TO CARE FOR LITHIUM-POLYMER (LiPo) CELLS
IN THE SAME WAY AS OTHER BATTERY TYPES! LiPo cells are much
more sensitive and volatile than NiCd or NiMH batteries. Misuse and
overcharge can quickly result in LiPo cells getting hot and/or swelling,
which could lead to VIOLENT EXPLOSION AND/OR FIRE and serious personal
injury and property damage.
●
NEVER attempt to recharge other battery types except 1S LiPo cells with this
built-in charger.
●
NEVER continue to charge or use LiPo cells if they start to swell or become
overly warm to the touch. Failure to follow this guideline could cause the battery
to become hot and explode or ignite!!
●
ALWAYS disconnect the battery from the charger immediately if the battery
becomes hot! Allow the battery to cool before use.
TACJ2402 Mnl.indd 5
TACJ2402 Mnl.indd 5
4/20/2011 9:51:26 AM
4/20/2011 9:51:26 AM
