Fig 7
Fig 6
Drive Belt Adjustment
See picture Fig 7
1. Remove four (4) large screws holding drive pad.
2. Remove four (4) screws holding the pad cover.
3. Loosen three (3) motor mount bolts.
Do not
remove the bolts.
4. Using a wrench, turn adjustment nut until it touches the adjustment bolt head. Turn the
adjustment bolt to tighten or loosen the belt tension.
5. Correct belt tension allows belt no more than 1/4" of side movement.
6. Tighten the four (4) motor mount bolts with the wrench.
7. Loosen the adjusting bolt until it is snug against adjustment stop molded in housing and
turn adjustment nut against pulley mount bracket.
8. Replace pad cover, pad driver and pad center grip.
TROUBLESHOOTING
Burnisher tends to move to the right.
• Do not lift up on handle while operating the burnisher.
• Do not operate with handle set too high. Recommended handle height is from your waist
with your arms extended forward.
Prevent circuit overload.
• Do not spray buff with the C1600. Apply a restorer, such as Powr-Flite’s Escalate, allow to
dry, then burnish.
• Check pad and change if dirty or rough.
• Check area being burnished for cleanliness, area should be damp mopped, scrubbed or
swept with treated broom.
• Operator should not continually force the machine with handle pressure.
• Operator should not try to operate burnisher in a side-to-side motion.
• Eliminate any extension cord that is smaller than 12/3 wire or greater than 25 feet in
length.
Burnisher will not start.
• Plug is broken or has loose contact. Replace.
• Switch is defective. Replace switch.
• Rectifier is defective. Replace.
Removable
Lid
Adjustment
Nut
Motor Bolt
