• The condition of the floor pad has direct affect on the performance of your bur-
nisher. When the pad becomes dirty, turn it over and use the other side. When
finished, wash the pad out and allow it to dry completely before using again.
• Unplug the power cord and wrap it under the cord hook and over the right han-
dle grip.
• Tip the machine back and remove floor pad.
• Wipe off the machine housing and the cord. This will prevent build-up of unnec-
essary residue.
TRANSPORTING THE M1200, M1600 AND
M2000
Use the rear wheels for transporting the M1200, M1600 or M2000. This will
insure that the operating wheels remain clean and smooth for use on clean floor
surfaces. (Fig 5)
MAINTENANCE FOR THE M1200, M1600
AND M2000
• Once a month, remove the motor cover of the unplugged M1200, M1600 or
M2000 by removing the motor cover screws.
• Vacuum out any dust or debris which has accumulated in the motor. (Fig 6)
• Replace motor cover and replace the motor cover screws.
• Check and maintain tightness of all fasteners.
WARNING:
do not over-tighten switch housing screws.
• Keep the burnisher clean, especially at the handle tube and collar so the
handle tube will move freely through the collar.
• Inspect cord and plug for cuts, gashes or loose prongs; replace as needed.
• The length of the carbon brushes should be inspected annually. If they are no
longer extended past the holder window, they should be replaced.
• Replacement of carbon brushes should be done only by a qualified service
technician.
•
Disassembly of this motor voids the warranty.
• Improper disassembly and assembly of this motor can permanently damage
the armature.
Fig 2
Fig 5
Fig 3
Fig 6
Fig 4
Switch Trigger
Safety Switch
