FUSE
SENSOR
MODE
SELECT
MODE
POWER
SENSOR
MODE
POWER
SENSOR
MODE
POWER
SENSOR
Blinking Yellow LED = Pulse Mode
Solid Yellow LED = Smart Mode
Mode
Select
MODE
POWER
SENSOR
Flashing Red LED = Check Sensor
(Refer to the troubleshooting section)
If circulator is equipped with a timer, turn the timer switch to full ON position.
SmartPlug will turn the circulator on after a 10 minute delay.
Power on circulator,
if applicable
Setting the SmartPlug Mode:
•
Smart Mode:
Learns your hot water usage
and adapts to your routines
•
Pulse Mode:
Continuously operates
5 minutes on, 10 minutes off
•
Vacation Mode:
After 36 hours of no hot water usage,
will remain off until hot water usage is detected
•
Exercise function:
While in vacation mode the SmartPlug will
cycle the circulator for 10 seconds every 7 days to prevent
any corrosion or scale build up
“Smart” or “Pulse” mode can be selected by pressing the
mode select button located on the lower right side of
the control box
To set the mode, make sure the SmartPlug is plugged
into a properly grounded 120V outlet
A yellow LED labeled “MODE” on the face of the
SmartPlug identifies the mode selected
The SmartPlug is also provided with a red “SENSOR” LED
If the sensor is properly installed the SENSOR LED will not illuminate.
If the red LED is flashing, refer to the troubleshooting section on page 3
To ensure the SmartPlug is providing hot water properly, open a hot
water tap at the fixture furthest away from the hot water tank
Set up complete, you are ready to enjoy hot water comfort
FUSE
SENSOR
MODE
SELECT
MODE
POWER
SENSOR
FUSE
SENSOR MODE
SELECT
MODE
POWER
SENSOR
Plug in the
SmartPlug
LEDs will
illuminate
and a
10 second
diagnostic
check will
begin
Plug in the
circulator cord
The green power LED
will illuminate
NOTE:
The circulator must
be a properly grounded
120V pump
-2-
10
mins
Press and release the mode select
button to switch between modes
NOTE: Use CAUTION as the water may be extremely hot.
Check for hot water
Step 3
Step 4
Step 5
Step 6
