Taco Electronic Solutions iWorX LCI3, Quick Start Manual

Page: 2 / 20

iWorx® LCI3
2 502-050A, Effective: April 22, 2013
© 2013 Taco Electronic Solutions, Inc.
QUICK START GUIDE
The iWorx® Local Control Interface Quick Start Guide provides simplified application information for the Local Control
Interface Controller. The Guide is designed as a supplement to the Application Guide and is not intended as a substi-
tute for it.
The reader should understand basic HVAC concepts, intelligent environmental control automation, and basic L
ON-
W
ORKS
networking and communications. This Application Manual is written for:
• Users who engineer control logic
• Users who set up hardware configuration
• Users who change hardware or control logic
• Technicians and field engineers of Taco Electronic Solutions, Inc.
APPLICABLE DOCUMENTATION
See the table below for additional documentation that may be applicable to this controller.
REPRESENTATIONS AND WARRANTIES
This Document is subject to change from time to time at the sole discretion of Taco Electronic Solutions, Inc. All
updates to the Document are available at www.taco-hvac.com. When installing this product, it is the reader’s responsi-
bility to ensure that the latest version of the Document is being used.
iWorx® products shall only be used for the applications identified in the product specifications and for no other pur-
poses. For example, iWorx® products are not intended for use to support fire suppression systems, life support sys-
tems, critical care applications, commercial aviation, nuclear facilities or any other applications where product failure
could lead to injury to person, loss of life, or catastrophic property damage and should not be used for such purposes.
Description Audience Purpose
iWorx® LCI3 Installation Guide , Docu-
ment No. 502-002
– Application Engineers
– Installers
– Service Personnel
– Start-up Technicians
– End user Provides detailed instructions for installing and
troubleshooting the iWorx® Local Control Inter-
face.
iWorx® LCI3 Application Guide , Doc-
ument No. 505-050
– Application Engineers
– Installers
– Service Personnel
– Start-up Technicians
– End user Provides detailed instructions for installing, con-
figuring, and operating the iWorx® Local Control
Interface.
http://www.iWorxWizard.com – Application Engineers
– Wholesalers
– Contractors An on-line configuration and submittal package
generator based on user input. Automatically
generates bill of materials, sequence of opera-
tions, flow diagrams, wiring diagrams, points
and specifications.
Additional
Documentation LonWorks FTT-10A Free Topology Transceiver User’s Guide, published by Echelon Corpo-
ration. It provides specifications and user instructions for the FTT-10A Free Topology Trans-
ceiver. See also: www.echelon.com/support/documentation/manuals/transceivers.