Battery state of charge
Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Direction preselection
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
Move the direction pre-selector
switch(7) to the required position:
– Left: counterclockwise (remove screws,
release screws)
– Right: clockwise (drill, insert screws,
tighten down screws)
– Middle: switch-on interlock (tool change,
when working on the power tool)
Switching on the power tool
To switch the power tool on:
Press the trigger switch.
The power tool trigger switch allows the
operator to increase the speed in
increments up to the maximum speed.
To switch the power tool off:
Release the trigger switch.
NOTE
– The power tool is equipped with a brake
which stops the cutting accessory as
soon as the trigger switch is released.
– When using the power tool continuously,
the operator should work primarily with
the trigger switch fully depressed.
Workplace lamp on/off switch
1. Turn direction of rotation pre-selector
switch (7) to “Forwards” or “Reverse”.
2. Press electric tool on/off switch (6)
– Workplace lamp lights up
3. Release electric tool on/off switch (6)
– Workplace lamp goes out
automatically after approx. 10 sec.
Change speed/torque
1. Activate on/off switch (6)
2. Press mode switch briefly (approx. 0.5 sec.).
– An LED lights up – torque:
T20:
2
5
0 N
.
m /
20
00
i
pm
6
