Tach-It 6510-TL, Setup And Instruction Manual

Page: 14 / 15

The label is not being removed
from the liner during the
feeding process.
Confirm that the label will peel cleanly from the liner by
removing a few labels by hand. If the surface of backing label
liner is peeling with the label, the die ‐ cut of the label is no good
and the machine will have difficulty peeling these labels. Try
another label roll or different label
Add tension to the label using the Top Urethane Pressure Plate.
See Figure 2.
The label is not applying as desired.
Confirm that the label is being fed up into the slot at least halfway.
See Figure 4. If the label is not feeding enough, use the Label Sensor
Adjustment Forward and Back to change how much the label is fed up
over the Top Plate. This will take some trial and error.
If the label is small and not adhering to the box or is not evenly
applied to the side and bottom of the box, raise the Brass Separator
Plate by using the Separator Plate Adjustment Thumb Screw. See
Figure 2.
IF the label is feeding more onto the side of the box and less on the
bottom reduce how much label is fed above the Top Plate by using
the Label Sensor Adjustment Forward and Back. This will take some
trial and error.