Quick Start Guide
Unpacking and
Initial Inspection
Unpacking and handling of the A10150 requires normal precautions
and procedures applicable to handling of sensitive electronic
equipment. The contents of all shipping containers should be
checked for included accessories and certified against the packing
slip to determine that the shipment is complete.
Installation &
Operating
Instructions
Being a passive device, there are no controls, nor computer
programming required to operate the A10150. The following
procedure is recommended for proper installation of the A10150
with the Tabor WX series and WS8351/2 models, however, model
A10150 can be used in conjunction with any signal source, simply
by using cables to connect to the amplifier:
1. Connect the input terminals to your source, using the
supplied SMA/M to SMA/M connectors, as shown in figure 2.
2. Connect the output terminal to your load
3. Connect the power input terminal to the supplied power
supply
WARNING
There is no switch control to turn A10150
amplification on and off and therefore, the
amplifier is active immediately after you power it
up. Always make sure your load is protected from
inadvertent power up conditions before you turn
on your A10150.
Figure 2, Connecting the A10150 to Tabor WX or WS8351/2 unit
6
