To remove FZ-G1 Hand Strap use a Phillips Screw Driver. Be sure that none of the
parts are lost in case you would like to use this hand strap again.
Install the Tablet EX Gear Hand Strap Replacement as shown below. Note: one of
the supplied machine screws is 2 mm shorter than the other seven – 12 mm versus
14 mm. This shorter machine screw must only be used in the location indicated on
the image below.
Failure to do so may damage your tablet computer!
Hand tighten the machine screws on all four corners of the tablet as shown above.
The machine screws should be snug but not over tightened or the threads may be
damaged.
