3.
Cable used for connection to power source, must
2 have across section of 1mm or greater. These
wires shall have insulation capacity made of at
least 1.5kV.
INSTALLATION GUIDELINES:
1.
This equipment, being built-in-type, normally
becomes a part of main control panel and in such
case the terminals do not remain accessible to the
end user after installation and internal wiring.
2.
Do not allow pieces of metal, wire clippings, or
fine metallic fillings from installation to enter the
product or else it may lead to a safety hazard that
may in turn endanger life or cause electrical shock
to the operator.
3.
3. Circuit breaker or mains switch must be
installed between power source and supply
terminals to facilitate power 'ON' or ‘OFF’
function. However this switch or breaker must be
installed in a convenient position normally
accessible to the operator.