Discovery DSC™ Getting Started Guide
Page 25
Chapter 2:
Installing the Discovery DSC™ System
Unpacking/Repacking the DSC
The instructions needed to unpack and repack the instrument are found as separate unpacking instructions
in the shipping box and in the online help associated with the instrument control software. You may wish to
retain all of the shipping hardware, pallets, and boxes from the instrument in the event you wish to repack
and ship your instrument.
Installing the Discovery DSC System
Before shipment, the DSC is inspected both electrically and mechanically so that it is ready for operation
upon proper installation. Only limited instructions are given in this manual; consult the online help for
additional information. Installation involves the following procedures:
•
Inspecting the system for shipping damage and missing parts.
•
Choosing a location for instrument installation.
•
Connecting the TA Instruments controller and instrument to the router.
•
Connecting gas lines to the Discovery DSC gas delivery module.
•
Connecting the power cables.
•
Installing a cooler option.
It is recommended that you have your DSC installed by a TA Instruments Service Representative; call for
an installation appointment when you receive your instrument.
CAUTION: To avoid mistakes, read this entire chapter before you begin installation.
MISE EN GARDE: Pour éviter de commettre des erreurs, lisez tout le chapitre avant de commencer
l'installation.
WARNING: Have an assistant help you unpack this unit. Do not attempt to do this alone.
AVERTISSEMENT: Faites-vous aider par une personne pour dépoter cet appareil. N'essayez pas
de le faire tout seul.
