Page 5
The Build
Please Note: Few pictures shown below are of different plane and for reference purpose only.
1
2
1. Building surface should be at least 2ft x 4ft and flat, Use a wax
paper over the surface to avoid sticking EPP on it when gluing.
2.
locate the hinged items as shown above,
Bend them back on to each other as shown and let set for at least 2
hours. This will help to loosen up the movement of the surface.
(This is mandatory step)
3. Make a neat line of hot glue over any old credit Card and spread it
over the hinge line show in the Next picture.
4. It is very important to put glue on card first and then Spreading a thin
layer over the hinge line otherwise If put directly over foam you might
end up melting EPP.
5. It is not required to put glue all the way to hinge line Just a inch of
glue on both inboard and outboard of the Surface will do the job.
6. Optionally one can clean up the rough edges using the sharp knife
for better cosmetic finish.
3
4
5
6