15 |
P a g e
1.
To fill water
:
The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa.
This is a pressure balance valve that requires you to lift the handle to start the water flow and to adjust to
the temperature that is desired. The clean jet body must be completely submerged in water.
CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2.
To start whirlpool
:
Press the button as shown. This will start your Clean Jet motor. You may stop the whirlpool function at any
time by pressing the button again.
3.
To drain Foot-spa bowl
:
Turn drain control knob to “pop-up” drain plug.
-
If gravity drain (no discharge pump); water in bowl empties with duration determined by waste water
plumbing
-
If optional discharge pump has been installed; then press discharge pump button to activate 2-
minute timer-controlled pump. Average drain time approximately one minute (depending on
plumbing characteristics).
4. The massag
e chair’s manual book will be sent separately.
Note: Read and Follow Chair Manual Instructions
INSTALLATIONS
Overflow
Mixer
Discharge
Pump Switch
(OPTIONAL)
Pump Switch
