12 |
P a g e
Plumbing Connections
1. Discharge pump may be connected to an existing sink drain or floor drain. It can also pump up
to 7 ft high, but this will increase the length of the drain time. The drain connection is at the rear
of the unit by a 3/4” fitting.
2. Gravity drain uses a standard gravity drain. A floor drain is recommended. P-Trap is not
installed nor supplied. The floor drain should already have a P-Trap and the UPC codes do
not allow double P-Traps in the system.
3.
Hot and cold water supply connections are located at the rear of the unit (½” fittings).
Please be advised that the hot and cold water supply lines are not fitted with optional back flow
Preventers unless ordered at initial sale.
4. Have a qualified licensed electrician to install the wiring according to local codes.
The Clean jets are 1/18 HP, 120V A.C., 0.55 AMP. 60HZ. GFI protected circuit must be used
to supply power to the unit. The roller back massage chair uses a 115V A.C. supply.
5. Spa base should be anchored securely to the floor. The base may be
anchored through the opening in the back of the base wherever
access is convenient for the installer.
6. Hand held sprayer. It has complied with applicable requirements of ASME A112.18.1-2005/CSA
B125.1-05
FAILURE TO ANCHOR THE BASE MAY RESULT IN PERSONAL INJURY OR DAMAGE TO THE UNIT.
DAMAGE AS A RESULT WILL VOID THE WARRANTY
Typical Gravity Sink (Direct Drain) Installation
INSTALLATIONS
Optional
3/8 Hot and
Cold Hoses
Drain Elbow
Gravity Sink 2’-
3’ to sewer line
