T.I.P. GS-48, Operator Instructions Manual

Page: 6 / 16

GS48
5
SET-UP
GS-48 Greens Spiker/Seeder
ASSEMBLY
If your GS-48 Spiker/Seeder came delivered on a pallet, first remove machine and all
parts from the pallet. Support the front of the machine and remove the jack from the
frame. Align the Draw Bar assembly with the center of the frame and attach with the
four U-bolts provided. Fasten the jack to the center of the draw bar assembly. The
Spiker/Seeder comes with two optional hitch assemblies; one clevis-type hitch, and one
1-7/8" ball-type hitch. Select the hitch that best fits your application, and attach it to the
front of the draw bar with the bolts and lock nuts provided. Select the holes that will
place the hitch at the correct height to keep the machine level. (see Leveling Machine)
CONNECTION TO TOW VEHICLE
Connect the Spiker/Seeder to your tow vehicle using either the ball hitch or the clevis
hitch provided. Be sure that connection is proper and secure. Be sure to rotate the
parking jack to it's horizontal position.
If your Spiker/Seeder will utilize the hydraulics on the tow vehicle, connect the hose
ends to the hydraulic ports on the vehicle. The quick connect ends on the hoses may need
to be changed to the correct size, depending on the hydraulic system on the vehicle.
CAUTION!
Make sure that hose ends are completely clean and free of all contaminants before
connecting to tow vehicle. Contaminants will cause damage to the hydraulic system.
If your Spiker/Seeder is equipped with the 12 volt hydraulic power unit, connect the two
power leads from the power unit to the battery on the tow vehicle. The power lead
marked with red tape goes to the positive side of the battery, and the black to the
negative. Be sure that the leads are properly secured so they will not vibrate loose or lose
contact during operation.
CAUTION!
Avoid direct contact with the battery terminals or the un-insulated portion of the
leads. Electrical shock could result.