5
4. Installation
4.1. General Safety Instructions on installation
Disconnect the unit from the mains before installation.
Do not force single components while assembling as this may damage the unit.
Pay due attention to the attached pictures at the end of this manual of instructions. The figures
hereafter which are put in brackets are referring to these pictures.
4.2. Safety guidlines (see
fi g. 1)
-Mains voltage and type of current have to correspond to the data on the type plate.
-Pull out mains plug before starting to work or maintenance on the pump, in the pond or aquarium
(disconnect the pump).
The pump should be placed so that it cannot fall in the water. Keep the pump dry. Fix the pump by
means of a string (A) which can pass through the hole at the back side of the pump. Caution! The
pump may travel due to the vibrations that result during operation. Ensure the pump is
fixed by the
string (A) securely before operation.
The pump should be placed at higher level than water surface (B).
The pump is designed for indoor use only!
The pump should not be used, if mains connection, plug or housing are damaged. If the supply cord is
damaged, it must be replaced by the manufacturer, its service agent or similarly quali
fied persons in
order to avoid a hazard. Any repair work should be done only by the manufacturer or by an authorized
repair shop who has on hand all the special tools.
16
Summary of Contents for API 100/1
Page 138: ......
Page 139: ...Abbildung 1 ...
