12
EN
• Turn the appliance off and disconnect it from the
power outlet prior to changing the accessories or
approaching parts that move while the appliance
is in operation.
DESCRIPTION
SAFETY SYSTEM
A
Pusher
B
Feed tube
C
Cover
D
Sieve
E
Juice collector
F
Pouring spout
G
Non-drip spout
H
Pulp collector
I
Safety clamps
J
Control button
K
Drive shaft
L
Motor unit
To start the juicer, the cover (C) must be fitted correctly (
Fig. 2
).
At the end of a cycle, turn the control button to “0” and wait until the
sieve (D) stops completely before removing the cover (C).
BEFORE FIRST USE
USING THE APPLIANCE
We recommend that you wash the removable parts (A, B, C, D, E, F, G, H)
before the first use (see section “Cleaning and care”).
• Unpack the appliance and then place it on a solid, stable worktop,
remove the cover (C) and take out the protective card on the sieve (D).
• Place the juice collector (E) on the body of the appliance (see
Fig. 1
).
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is
properly clipped onto the drive shaft (K) (see
Fig. 1
).
• Fit the cover (C) on the appliance, pulp ejection spout (see
Fig. 2
).
• Fit the cover (C) on the appliance in order to have the pulp evacuation
exit to the rear (see
Fig. 2
).
• Lock the two clamps (I) on the cover (C). You will hear an audible “click”
(see
Fig. 4
).
• Slide the pusher (A) into the feed tube (B) aligning the groove on the
pusher with the small ridge in the feed tube.
• Your appliance is equipped with a non-drip spout (G). Fit it (spout
downwards) on the pouring spout (see
Fig. 5
).
