19
Troubleshooting
• Use a wooden or plastic spoon to prevent any damage to the coating of the cooking pot.
Never cut food directly in the cooking pot.
• During cooking & steam release, the appliance emits heat and steam. Keep your face and
hands away from the steam flow. Do not touch the lid during cooking
- fig. 22
.
• If a great deal of steam is released from the rim of the lid, unplug the power cord at once,
and send the appliance to our service center for repair.
• If the alarm beeping sound is on for more than 1 minute, please do not use the appliance
and send the product to a service center.
• Do not carry the appliance by the lid handle. Use the 2 side handles to transport the
product.
• You must not take the appliance apart or replace any components yourself (except the
sealing gasket). This can be done by an authorized service center only.
• Do not replace the power cord with other cords.
• Keep out of the reach of children.
• Do not use the cooking pot on the stove or in any appliances.
• If pressure is released continuously (for more than 1minute) while pressure cooking, send
the appliance to a service center for repair.
• Do not operate the pressure cooker without the cooking pot.
• When opening the lid, always hold the lid by its handle. In some cases, boiling water may
be trapped between the gasket support cover and the lid. This can cause severe scalding.
TROUBLE
POSSIBLE REASONS
SOLUTION
The appliance beeps and
the display shows
.
• The appliance is unable
to build up pressure.
• Check that the lid is
closed properly and that
the pressure limit valve is
in the correct position
- fig. 11.
The appliance
automatically switches to
Keep Warm without going
through a complete
cooking cycle.
• When there is not
enough water in the
cooking pot,
the appliance will switch
to the Keep Warm
setting.
• Add more water in the
cooking pot and restart
the cooking cycle.
Lid will not lock.
• The sealing gasket and
sealing gasket support
cover are not installed
properly.
• The float stays up.
• Properly install the
sealing gasket and the
sealing gasket support
cover.
• If this occurs just after
cooking, remove the valve.
Then close the lid and
place the valve back into
position. If the product
has not been used and is
cold, push the push rod in
directly with your hands.