ON PILLOW BLOCKS. PUSH (2) SNAP TOOTH RINGS ONTO SWING ARM SHAFT ON INSIDE OF
PILLOW BLOCKS. TIGHTEN INSIDE COLLARS ON WEIGHT BARS. RECHECK DIMENSION ON
TOP AND BOTTOM OF SWING ARM. ADJUST INSIDE COLLARS TO HOLD DIMENSION.
INSTALL OUTSIDE COLLARS AND TIGHTEN SET SCREWS. INSTALL (2) WEIGHT COLLARS.
(8) ATTACH (2) ARM PAD TO ARM PAD MOUNT WITH (4) 3/8 X 2 1/2 BOLTS AND (4) 3/8 FLAT
WASHERS FINGER TIGHT. CENTER ARM PADS AND TIGHTEN HARDWARE. DO NOT OVER
TIGHTEN.
(9) ATTACH (2) HIP PAD TO HIP PAD MOUNT WITH (4) 3/8 X 1 BOLTS AND (4) 3/8 FLAT
WASHERS FINGER TIGHT. CENTER PADS AND TIGHTEN HARDWARE. DO NOT OVER TIGHTEN.
(10) INSTALL (11) 2 PLUGS AND (2) 1 3/4 PLUGS.
HARDWARE LIST
(4) 3/8 X 3/4 BOLTS
(4) 3/8 X 2 1/2 BOLTS
(14) 3/8 X 3 BOLTS
(1) 3/8 X 5 BOLT
(4) 3/8 X 1 BOLTS
(42) 3/8 FLAT WASHERS
(15) 3/8 LOCKNUTS
(4) 1/2 X 3 1/2 BOLTS
(8) 1/2 FLAT WASHERS
(4) 1/2 LOCKNUTS
(5) 3/8 HANDKNOB
(2) 3/8 POP PIN
(3) 3/8 "L" PIN
(3) 2 X 4 FOOT
(11) 2 PLUG
(2) 1 3/4 PLUG
(2) 1 HANDLE
(2) 1 WEIGHT COLLARS
(2) 3/4 SNAP TOOTH RING
(2) PILLOW BLOCK
(1) TURN POP PIN
NOTE: ALL ARE EXPRESSED IN INCHES.
