T+A A 200, User Manual

Page: 29 / 36

4
Loudspeaker terminals
SPEAKER RIGHT
SPEAKER LEFT The A 200 is equipped with two pairs of speaker terminals.
It is possible to connect two pairs of loudspeakers (2-zone operation). In this case,
the impedance of each speaker must not be less than 8 ohms (according to DIN).
Instead of 2-zone operation, the two outputs can also be used perfectly for bi-wiring
operation.
j
If the loudspeakers are to be used in countries outside the EU the red/black stoppers can
be removed from the loudspeaker terminals. The speakers can then be connected using
banana plugs.
The stoppers are simply a push-fit in the terminals, and can be prised out from the rear
using a suitable tool such as a knife blade.
5
System link
E2 Link This socket can be used to control the A 200 via the DAC 200. Connect this socket to
the E2 Link socket of the DAC 200.
6
Mains input
The mains cable is plugged into this socket.
For correct connection refer to the sections
Installation and Wiring and Safety Notes .
29