F-23837-5
©
Copyright 2006 TAC All Rights Reserved.
9
Mounting TS-57011-770 or TS-57011-850 Series Sensor on European 1/4 DIN
Standard Electrical Box
1. Remove the sensor cover from the base plate, according to the following:
a. Insert the blade of a small-bladed screwdriver into the cover latch slot in the bottom
of the sensor cover (see Figure-7 ).
b. Gently push upward on the screwdriver to release the cover latch.
c. Rotate the cover away from the base plate while removing the screwdriver from the
cover latch slot.
2. Separate the wall plate from the base plate (see Figure-8 ). The wall plate is snapped
onto the base plate. The wall plate may be discarded or used as a cover plate.
3. Using diagonal wire cutters, cut the mounting tabs from the top and bottom of the base
plate (see Figure-9 ).
4. Identify the two wires that are to be connected to the sensor. Route these wires from
the electrical box and through the wire feedthrough opening near the top of the base
plate (see Figure-10 ).
Figure-9
Removing Mounting Tabs.
A
m
e
ri
c
a
n
To
ol
D
ia
g
o
n
a
lC
utte
rs
Sensing Element
Diagonal Wire
Cutters
Cut Mounting
Tab Here
Cut Mounting
Tab Here
