SNOOZE/LIGHT FUNCTION
During the wakeup
press the SNOOZE/LIGHT bu on once to temporarily turn o
ff
the alarm.
A er approximately 9 minutes the alarm will sound again. The cycle will repeat when the SNOOZE /
LIGHT bu on is pressed again. Alarm max last for 1 hour
Note:
When pressing the SNOOZE / LIGHT bu on, the panel backlight will turn on, and will turn o
ff
automa cally er 1 minute.
SLEEP FUNCTION
The sleep
is used for automa switch-o
ff
of the Radio
SPECIFICATIONS
Radio Frequency : FM – 87.5 – 108MHz
Antenna
: External Antenna Wire
Output
: 500mW Max.
Speaker
: 50mm, 8ohm x 1
Power Required
: Input 230v 50Hz
Clock backup – DC3V, 1 x CR2032 ba ery (ba ery included)
While every e
ff
ort has been made to ensure all informa
contained in this manual is correct, design
and spe
cifi
ca
re subject to change without no e.
E-4
PROJECTOR
Press and hold the SNOOZE/LIGHT button for the backlight to always be ON. Press and hold once
more for the backlight to return to its normal status.
If you wish to hear the radio for a certain time before going to sleep, press the “MODE” button to
switch to the radio mode. Search the desired channel by pressing the SCAN+ or SCAN- button. At
this moment, press the SLEEP button and the display will show 90 min. Press the SLEEP button until
you have set the desired time for the unit to off. The options for the SLEEP function are as follow:
90, 60, 30, 15, Off. Once the selected time has elapsed, the radio will automatically shut down.
BRIGHT OR DIM SET
The negative display of the SY-1033 is perfect for the night as it does not reflect the numbers.
To increase the luminosity of the display, press the LIGHT button for the display to brighten up.
After approximately 1 minute, the display will return to the original dim light.
TIME MEMORY SET
The SY-1033 includes a battery backup feature in case of power failure. Plug in the radio clock to
the mains output. Adjust al the parameters such as the year, month, date and time. Open the battery
compartment located at the bottom of the unit and insert 1 x CR2032 battery in the correct position
(included). In the case of any cut off power, the SY-1033 will retain the actual time and date until the
main power comes back.