4
Charging the internal battery.
Make sure the battery is fully charged before starting to use the Boxbeat speaker.
Connect the USB power cable (supplied) to your PC and the other end to your Boxbeat
speaker.
Make sure the cables are well connected.
The unit can be turned to OFF or to ON as this will not vary the charging process.
Charge the battery for 4 hours the first time. Later on you can charge it for 3 hours.
The Boxbeat can also play and charge at the same time. When the Power is ON and music
is playing, simply connect the same USB power cable to your PC or a compatible AC
power adaptor 5V.
Batteries have a limited life and therefore when the battery does not charge anymore,
replace it for a new one. (Battery Warranty: 6 months).
It is always recommended to fully charge and discharge the battery as it will help the
battery to have a longer life. Do not intend to charge the battery when it is half full, at this
point; wait until the battery is fully exhausted to recharge it.
Playing back music through a USB.
Plug in a USB pendrive and make sure MP3 files have been recorded into the flash drive.
As soon as the USB has been inserted, the Boxbeat will playback the first track.
Adjust the volume by pressing the VOL+ or VOL- buttons.
Press the or buttons to access to the previous or next track.
Press the button to pause or stop a song.
Playing back music through a MicroSD memory card.
Insert a MicroSD card inside the Boxbeat speaker slot.
As soon as the MicroSD has been inserted, the Boxbeat will playback the first track.
Adjust the volume by pressing the VOL+ or VOL- buttons.
Press the or buttons to access to the previous or next track.
Press the button to pause or stop a song.
Note, when the USB and the Micro SD card are inserted in the same time, you will need
to press the USB/SD/FM button to select the desired device you wish to play.
Listening to the radio.
Plug in the supplied wired antenna cable at the back of the unit.
Press the USB/SD/FM button until you switch to the radio mode.
To search a station, simply press the buttons until you have found the desired
station.
To scan automatically to the next channel, simply press and hold the buttons
for approximately 2 seconds. The Boxbeat will automatically search the next available
