Systemline SN1100, Quick Start Instructions

Page: 4 / 12

1.0 NetServer pack contents
1 x NetServer
2 x Mounting brackets
4 x Bracket fixing screws
1 x Power supply
1 x Mains cable
1 x Quick start instruction manual
2.0 NetAmp pack contents
1 x NetAmp
2 x Mounting brackets
4 x Bracket fixing screws
4 x IMO speaker connectors
4 x HomeNet cabinet fixing screws
1 x Right angled mains cable
2 x USB A-B cables
3.0 Introduction
These quick start instructions describe how to configure the S7 NetServer with 2 zones of an S7
NetAmp. Please refer to the detailed instructions available on the Systemline website for other
configuration, connectivity and mounting options.
4.0 Connections
4.1 Use an Ethernet patch cable (not supplied) to plug the Local Area Network connection of the
NetServer and NetAmp into the router network sockets. The router should have an active DHCP
server (automatically assigning IP addresses).
4.2 Use two USB A-B cables to connect inputs 3 and 3A of the NetAmp to two of the NetServer’s
USB sockets.
4.3 Once the speakers are connected correctly in the two zones, use the green speaker plugs
included with the NetAmp to terminate the zone speaker cables and plug into the speaker
sockets on the NetAmp.
4.4 Plug in the mains cable for the NetAmp.
4.5 Plug in the NetServer power supply and switch on.
Please note: It is important that you connect the USB cables and switch the NetAmp on before
switching the NetServer on.