6
3.3
Transport and storage
Topvex SF is delivered in one piece standing on a pallet for easy transportation using a forklift. The unit should be stored
and transported in such a way that it is protected against physical damage that can harm panels, handles, display etc. It
should be covered so that dust, rain and snow cannot enter and damage the unit and its components. The appliance is
delivered complete with all necessary components, wrapped in plastic on a pallet for easy transportation.
When transporting the Topvex SF units use a forklift placed on the gable of the unit.
Note:
Necessary parts like control panel, supply air sensor, handles, mounting brackets are placed inside the unit.
The unit must not be put into operation before the enclosed parts are removed and installed properly.
Warning
The unit is heavy. Be careful during transport and installation. Risk of injury through pinching. Use protective
clothing.
4
Installation
4.1
Unpacking
Verify that all ordered equipment are delivered before starting the installation. Any deviation from the ordered equip-
ment must be reported to the supplier of Systemair products.
4.2
Where/how to install
Topvex SF02-SF12 can be installed outside if weather protected. An outdoor air section, ODS is available as accessory.
If the unit is installed in a cold place it is important that the unit is not shut-off by the main switch. As long as the main
voltage is on the electrical cabinet will be kept warm also in cold climates.
When choosing the location it should be kept in mind that the unit requires maintenance regularly and that the inspec-
tion doors should be easily accessible. Leave free space for opening the doors and for taking out the main components
(chapter 3.2.1.)
The outdoor air intake of the building should if possible be put in the northern or eastern side of the building and away
from other exhaust outlets like kitchen fan outcasts or laundry room outlets.
Warning
• The door handles are only intended to be used during the installation and service. Handles must be
removed before the unit is put into operation to ensure the required level of safety for the unit.
• The unit must be duct connected or in some other way provided with protection so that it is not possible
to come in contact with the fans through the duct connections
130324 | A004
Summary of Contents for Topvex SF Series
Page 4: ......
Page 21: ...Control panel 17 130324 A004...
Page 22: ...18 Control panel 130324 A004...
Page 23: ...130324 A004...
