32
14
Quick configuration guide
Access software 4.0-1-04 to 4.4-1-01
14.1 How to set up a function
To set up a function in the access controller you need to be logged in as Service to access the configuration menu. After
login you follow a 4-step procedure to successfully setup the function. Please note that not all functions require all four
steps. The general procedure for setting up a function is described below. Function specific configuration guides are
found later in the document.
14.1.1
Login
Log in with service mode using password 0612.
Overview:
Service
0612
Login
Step by step:
1.
Open the log in window
2.
Select service from drop down list
3.
Type in password 0612
4.
Press Login.
14.1.2
Activation
Configuration
>
Functions
>
Function activation
Activate a function in a list of available functions (e.g. heater).
14.1.3
Configuration
Configuration
>
Functions
Select the function's configuration (e.g. if heater is water, electric etc.).
14.1.4
Allocation
Configuration
>
I/O allocation settings
Select the I/O (in-/output) placement of the connected signals and sensors. Configure I/O settings (sensor measuring
range, polarity, edit name of sensor/signal etc.).
Caution
Do no use the same in- or output for several functions.
14.1.5
Operation settings
Data & Settings
Setup how the function will work (e.g. setpoints, limits etc.)
254051 | A001
