2
Interfaces and Features
Reset button
Button used to reset the gateway. Use paper clip, or
similar device, to press. To reboot the gateway,
press the reset button momentarily. The status light
will alternate between orange and red during the
reboot.
To reset the gateway back to factory defaults, hold
for about 10 seconds. When the status light
alternates between red and green, you may release
the reset button.
Status light
Indicates current gateway status. Solid amber at
initial power up. Blinking green at one second
intervals during normal operation.
Cell On light
If cellular option installed, then this light indicates
the cellular is operating.
Cell Strength light
If cellular option installed, then the number of lights
indicates cellular signal strength. These lights are
active even if cellular is currently not in use.
5V Power port
Use included power adapter. Optionally may use
other 5v DC power source. See technical
specifications for power requirements.
ATM/POS port
If the ATM/POS option installed, then this port
functions as a DCE or modem. Plug a DTE device into
this port. The light to the right of the port flickers
green during normal operation.
Serial port
If the serial option installed, then this port provides a
serial interface. Plug a serial device into this port.
The light to the right of the port flickers green during
normal operation.
Cell Aux and Cell Main
If cellular option installed, then attach cellular
antennas here. Cell Main is required. Cell Aux is
optional for improved connectivity and speed.
Ethernet 1 (LAN port)
Local Ethernet connectivity, usually used to attach
additional local LAN devices (or local network hub) to
the network. The yellow light indicates a link. The
green flickers during normal operation.
Ethernet 2 (WAN/LAN port)
Source for Internet connectivity, usually connected
to broadband modem or a local network that
provides Internet access. May optionally be
configured for local Ethernet connectivity, usually
used to attach additional local LAN devices (or local
network hub) to the network. The yellow light
indicates a link. The green flickers during normal
operation.
Brass inserts
The four brass inserts, located near the four corners
of the gateway, may be used for optional bracket
hardware. This may be useful for DIN rail mounting,
for example.
SL-800
Front
Back
