2021V1.0
Transmitter Panel Description
Tx
Rx
SIG
MER
GE
BYP
ASS
CO
PY
TX
E
D
ID
1
2
3
4
5
6
7
8
1. CAT OUT: Connects to the CAT IN port of receiver by CATx cable. It supports 12V PoC and
the transmitter can be powered from the receiver. The green LED illuminates when power
is applied. The orange LED illuminates when there is a valid HDMI signal input.
2. IR IN: Connects to IR receiver for IR pass-through.
3. IR OUT: Connects to IR emitter for IR pass-through.
4. RS232: Connects to RS232 control device (e.g. PC) or a third-party device to be controlled
for RS232 pass-through.
5. DISPLAY: Connects to local HDMI display device.
6. SOURCE: Connects to HDMI source device.
7. EDID: 3-pin DIP switch for EDID setting.
MERGE: If there are two display devices in this system, the unit will output the video
with the lower resolution in this mode to ensure video can be shown on both displays.
BYPASS: The source device learns the EDID from the remote display connected to the
Receiver’s HDMI output.
COPY Tx: The source device learns the EDID from the local display connected to the
Transmitter’s HDMI loop output.
8. DC 12V: DC connector for the power adapter connection.
Receiver Panel Description
Tx
Rx
SIG
IN
1
2
3
4
5
6
1. CAT IN: Connects to the CAT OUT port of transmitter by CATx cable. It supports 12V PoC
and the receiver can be powered from the transmitter. The green LED illuminates when
power is applied. The orange LED illuminates when there is a valid HDMI signal input.
