13
3.5 Network Camera Setup
This section describes how to configure the network camera, and is intended for product.
Administrators, who have unrestricted access to all the Setup tools; and Operators, who have
access to the settings for Basic Configuration, Live View, Video & Image, Audio, Event, Dome
Configuration, System
You can configure the network camera by clicking Setup in the top right-hand corner of the Live
View page. Click on this page to access the online help that explains the setup tools.
When accessing the network camera for the first time, the “Admin Password” dialog appears. Enter
your admin name and password, set by the administrator.
NOTE:
If the password is lost, the network camera must be reset to the factory default settings.
Please see “Resetting to the Factory Default Settings”.
Resetting to the factory default settings
To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in “3.5.7 System > Maintenance” of User’s Manual) or use the
Reset
button on the network camera, as described below:
•
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings using the
Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Press and hold the Reset button (SW1) on the board with your finger while reconnecting the
power.
3. Keep the Reset button (SW1) pressed for about 2 seconds.
4. Release the Reset button (SW1).
5. The network camera resets to factory defaults and restarts after completing the factory reset.
CAUTION:
When performing a Factory Reset, you will lose any settings that have been saved.
(Default IP 192.168.30.220)
