the master only, shows the basic information about all devices under management and supports
the modification of their parameters and the query of such information as channel state, recording
files, statistics reports and operating logs. The interface
Master/Slave Settings,
open to both the
master and the slave(s), is used to set the working mode (master/slave) and the number of the
current device.
3.11.1 Management
Figure 3-52 Management Interface
See Figure 3-52 for the
Management
interface where the device list shows all devices under
management in the network. Only the master device users with the centralized management
authority can enter this page to query or configure the information of the slave devices. A new
device can be added to the list by the
Add New
button at the bottom of the list. See Figure 3-53
for the slave device adding interface.
Figure 3-53 Add Slave Device
Enter an IP address to add a new device. Another way to add a new device to the list is to click the
Search
button at the bottom of the list in Figure 3-52. However, only those devices in the same
network segment will be found out in this way. For example, if the IP address of the master device
is 192.168.1.5, only those slave devices in the network segment from 192.168.1.1 to
192.168.1.255 can be searched, and those in another segment shall be added manually. See
Figure 3-54 for the device searching interface. The number displayed on the right side of the
interface indicates the time used for searching.
Figure 3-54 Device Searching
Please wait for a while until a dialog pops up and prompts
‘
Searching completed!
’
. Then all
searched devices will appear in the device list in Figure 3-52.
The table below explains the items shown in Figure 3-52.
Item
Description
Device No.
Number of a device under the centralized management.
Device IP
IP address of a device under the centralized management.
Total Channels
Total number of channels used by a device under the centralized management.
ATP2410 User Manual (Version 4.0.0.0)
Page 45