SYNTHESIS TECHNOLOGY
PAGE 4
MOTM-850 ASSEMBLY 10/25/01
WWW.SYNTHTECH.COM
GENERAL INFORMATION
Thank you for purchasing the MOTM-850 Pedal Interface. If you have any issues
concerning the building or use of the kit, please contact us at (817) 281-7776 or by email:
[email protected]
This kit should take the average builder between 2 to 3 hours. The kit contains many
different resistors and special parts. However, please remember this is NOT a speed
contest; it is an accuracy contest. There is no rule that you have to complete the entire kit
in one day (as long as you wash the flux off!).
Successful kit building relies on having the proper tools. Here is a list of what you will need
to build your MOTM-850:
•
Soldering iron, 50W max power
•
Needle-nose or chain-nose pliers
•
Diagonal cutters
•
Allen key set for securing the knobs (1/16” or 1.6mm)
•
Magnifying glass: to read the capacitor codes and to inspect solder joints
•
Lead bending tool (optional, but makes the job go much faster)
•
DVM (Digital Volt Meter) or oscilloscope (to check the output)
•
#1 Philips screwdriver
•
Fingernail brush for washing off the organic flux
•
Old towel for blotting dry pc board
•
Heat-shrink gun is highly recommended!
For more information of tools used and suggestions, see the MOTM FAQ and Tutorial pages
at
http://www.synthtech.com
.
HOW TO FOLLOW THE DIRECTIONS
Please read the entire instruction before proceeding. There may be valuable information at
the end of the instruction. Each instruction has a check box
next to it. After you
complete the instruction, check the box. This way you can keep track of where you are in
the process.
VERIFY THE PARTS LIST
Verify that all of the parts are in the kit as shown on the parts list.
Summary of Contents for MOTM-850
Page 21: ......
