11
Chapter 2: Hardware Setup
4
Check
Total Physical Memory
in
Main Menu
>
System Information
.
If your RackStation does not recognize the memory or does not start up correctly, please make sure the memory
was correctly installed.
Remove a RAM Module from RackStation
1
Follow steps 1 and 2 of “Install a RAM Module” to remove the cover from your RackStation.
2
To remove the RAM module, follow the steps below:
a
Release the ejectors on the memory slot by pushing them toward the sides.
b
Hold the memory module by the edges and remove it from the slot.
3
Replace the top cover, slide it into place, and tighten the two back screws.
Add a Network Interface Card to RackStation
Your RackStation contains a PCI Express expansion slot which allows you to install a 10G/E or Gigabit network
interface card for LAN port expansion.
---------
1
For more information about supported 10G/E or Gigabit network interface cards, visi Before installing the card on your RackStation, you must replace the
longer bracket (for PC usage) on your network interface card with the shorter bracket (for RackStation usage).
8192 MB
RackStation
