• Never operate generator without water
in the bottle.
• Keep USB-C port sealed by plugging its
cover back in.
• Operate only with filtered water.
• Not for use with hot, carbonated, or
non-water beverages.
• Always keep electrode plate wet and
never store dry.
• Unit will stop charging when LED lights
turn green.
• Do not place generator unit in a
refrigerator or cooler.
• Do not soak or submerge generator unit
under water.
• Drink hydrogenated water within 3 to 5 hours.
• Avoid direct sunlight or heat that can dry
out the electrode plate.
• Use room temperature water. Never freeze
or use ice.
• Never use any chemical cleaners on
generator unit.
• Keep out of reach of children and pets.
• Keep away from heat and flames.
• Unplug by pulling the plug, not the wire.
• Do not unplug device with wet hands.
ADVISORIES
Depending on the mineral oxide content in your
filtered water, clean the electrolysis plates by
descaling once or twice a month.
To descale, add 1 part white vinegar, lemon juice,
or citric acid and 3 parts water in the bottle and
leave generator soaking in mix overnight.
Dump and rinse thoroughly with warm water
before using the next day.
Disclaimer: These products have not been evaluated
and are not intended to diagnose, cure, treat, or
prevent disease. Seek medical advice if seriously ill
or attempting to cure or prevent disease.
OCCASIONAL DESCALING
MAINTENANCE
Keeping your machine plugged in all day during use
may cause your battery to fail prematurely.
Do not keep plugged in past the allotted 2 to 3 hours.
01.
Short press the button. The working indicator
light will turn blue, making hydrogen-rich
water for 3 minutes (0.8 ppm). Short pressing
the button twice in a row will turn the working
mode to 10 minutes (up to 1.8 ppm). Run the
10-minute cycle a second time to achieve
hydrogen water with 3.0 ppm. Pressing
the button when the unit is working will
turn the power off.
02.
After a 3- or 10-minute cycle, the working
indicator light will turn off, completing the
process.
03.
You can drink the hydrogen-rich water
directly out of the bottle or pour it into
another container. It is best to drink the
water within 3 to 5 hours. Hydrogen will
dissipate over time.
04.Self-cleaning:
Press and hold the button for
3 seconds. The working indicator light will
turn green, the positive and negative
electrodes will be swapped, and the
machine will enter the self-cleaning mode.
This mode, which takes about 3 minutes,
will create oxygen instead of hydrogen to
kill bacteria.
Do not drink the water from
the self-cleaning cycle. Pour it out.
05. Charging:
If the working indicator light
flashes blue, this means the battery
power is low and needs to be charged.
The USB-C charging port is located
underneath the rubber cover on the back
of the generator. Plug the USB-C power
cable into the USB-C power adapter and
plug the adapter into the wall. The LED
light will turn red when it is charging.
When charging is complete, the LED light
will turn green. Unplug the device and
make certain the rubber cover is inserted
into the USB-C port. This will keep water
from entering the generator.
OPERATION
Summary of Contents for echo GO
Page 1: ...USER MANUAL ...