Symphony SYK-2015, Setup Instructions, Page: 6 / 10

© 2020
Step 2 of 6
Locked layer contains
placeholder marks.
Item
1
2
3
4
5
6
7
8
9
Qty.
1
1
1
1
1
1
1
1
1
Description
45”h TSP49 Vertical Extrusion
45”h TSP49 Vertical Extrusion
45”h TSP49 Vertical Extrusion
45”h TSP49 Vertical Extrusion
27.35”w TSP49 Horizontal Extrusion
27.35”w TSP49 Horizontal Extrusion
27.35”w TSP49 Horizontal Extrusion
27.35”w TSP49 Horizontal Extrusion
6” x 22” End Base Plate w/ foot
When assembled
Tool-less Spline Connector
1. Place extrusions end-to-end.
2. Slide tool-less connectors
across seam of extrusions.
*
3. Tighten all knobs to secure connection.
Tool-less Corner Connector
1. Slide extrusion onto
Corner Connector.
2. Tighten all knobs to
secure connection.
*
Keep corner connectors attached to horizontal extrusions.
Assemble frame flat on ground.
Steps:
Refer to the Tool-less Frame Assembly general information page.
1) Assemble vertical extrusions [ 1-2 ], [ 3-4 ] & horizontal
extrusions [ 5-6 ], [ 7-8 ] together, using Tool-less Spline connectors .
2) Connect vertical assemblies [ 1/2 ], [ 3/4 ] between horizontal
assemblies [ 5/6 ], [ 7/8 ], using Tool-less Corner Connectors .
3) Install Base Plate [ 9 ] to bottom corners of frame assembly
as shown. See Base Plate Attachment detail.
1) Place key hole over bolt on panel
& slide down.
2) Twist knob to secure connection.
Base Plate Attachment
*
bolt
knob
Base Plate
threaded
hole
key hole
*
1
2
3
4
5
6
7
8
9
FRONT VIEW
*
*
*
*
*
*
*
*
Left Backwall Frame Assembly