Symmetricom TimeSource 3600, Manual

Page: 127 / 254

TL1 Reference
127
2
4
5
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
4
Parameters
The parameters that may be used in commands, responses, and
messages are defined in Table I. When a parameter uses the same
values in every instance, those values are listed with the
parameter in the table. When the context requires different values
for a parameter, the value is listed with the parameter in the
applicable commands, responses, and messages.
Table I. Parameter Definitions
Parameter Definition
<aid> Access identifier for the object of the command or message. It may have more
than one part.
<almcde> Alarm code. Identifies the severity of the alarm based on its priority of action. If
multiple alarms are reported, almcde is the highest severity of those reported.
<atag> Automatic message tag. It is incremented by one for each autonomous message.
The <atag> value is a whole number from 001 through 999, which is reset to
001 at reset or when it rolls over.
<command> Echo of the entered command.
<conddescr> Text description of the condition. The <conddescr> value is limited to
64 characters starting and ending with a backslash and a double quotation mark
(\"). Refer to the Troubleshooting chapter of this manual for the list of values.
<condeff> Effect on the condition of the equipment.
<condtype> Type of alarm condition.
<ctag> Correlation tag used to correlate input and response messages. The ctag
contains 1 to 6 characters. It must be included in a command, and the same ctag
is returned in the response.
<date> Date in the 8-digit form: yyyy-mm-dd (command) or yyyy:mm:dd (response or
message), where yyyy is the year, mm is the month (01 to 12), and dd is the day
of the month (01 to 31). For example, May 3, 2000 is 2000-05-03.