Symmetricom TimeSource 3600, Manual

Page: 116 / 254

116
TimeSource 3600
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
31 If not using the TOD output, skip to Step 32. Use the Edit Equipment command to
set the TOD output.
ED-EQPT::TS3600:<ctag>:::TOD=b;
b = TOD format (b = Cisco or NTP4)
32 Use the Edit Equipment command to allow or inhibit alarm conditioning on the
outputs. Inhibiting the alarm conditioning forces the TimeSource 3600 to continue
to output valid timing signals while in major alarm. This may be useful when testing,
troubleshooting, or in installations where a TimeSource 3600 that is in major alarm
may produce better timing signals than other sources (for example, offices without
additional holdover clocks in a distribution shelf).
ED-EQPT::TS3600:<ctag>:::ALMCOND=b;
b = alarm conditioning of the outputs (b = ALW or INH)
33 Use the Copy Memory command to copy the database from volatile to nonvolatile
memory within the TimeSource 3600.
CPY-MEM:[tid]:TS3600:<ctag>::WKG,,AUX:DATA;
Note:
Although the database is automatically copied to nonvolatile memory once
per hour, it is recommended that the Copy Memory command be executed each
time the database is changed.
Procedure G. Power Up (cont’d)
Step Procedure