Symmetricom TimeProvider 500, User Manual

Page: 169 / 174

098-00172-000 Revision A – December, 2009 TimeProvider 500 2.0 User’s Guide 169
Parameter Changes and Additions – Version 1.0 to Version 2.0 Firmware
Parameter Changes and Additions – Version 1.0 to Version
2.0 Firmware
Table C-14 contains a list of the TimeProvider 500 parameters that either change or
are new when upgrading from version 1.0 to version 2.0 firmware. If a parameter is
not listed in
Table C-14 , then the parameter will retain its value after upgrading to
release 2.0 firmware.
Table C-14. Parameter Changes and Additions – v1.0 to v2.0 Firmware
Parameter
Release 1.0
Firmware
After Upgrade from Version 1.0 to
Version 2.0 Firmware
set alarm-config delay Any value 3
set alarm-config level Any value MAJOR, except 15 is EVENT
set alarm-config state Any value Enable
set alarm-config proxy N/A Disable, except for 0,1,3,4,15
set auto-neg N/A True
set bridge-time n n+120, not greater than 86400
set clock timescale N/A UTC
set clock timezone N/A 0
Set interface Non-VLAN address

Enable only if0

Make if0 ip addressing the same as
version 1.0

All attachments to if0
VLAN address

Enable only if1

Make if1 ip addressing the same as
version 1.0

All attachments to if1
set ipdv interval N/A 1
set ipdv pacing N/A 16
set ipdv threshold N/A 50000
set output out1|2 Any value Both outputs set to version 1.0 output
set output pps-mode N/A Standard
set output pps-offset N/A 2984
set output pps-width N/A 500
set ptp domain 0 – 127 Range is 0 – 255