Symmetricom TimeProvider 500, User Manual

Page: 147 / 174

098-00172-000 Revision A – December, 2009 TimeProvider 500 2.0 User’s Guide 147
Appendix B Configuring the TimeProvider 5000 and 500
Example
TimeProvider 5000 and 500 Configuration Example
Table B-1 lists the actions to configure the TimeProvider 5000 and TimeProvider
500 and to verify that network communication between the TimeProvider 5000 and
TimeProvider 500 is enabled. In this example, the TimeProvider 500’s configuration
is for non-VLAN Ethernet interface if0.
Table B-1. TimeProvider 5000 and 500 Configuration
TimeProvider 5000 TimeProvider 500
Connect to Craft Port
Use serial cable to connect Craft port to serial port
of laptop computer.
Connect to Craft Port
Use serial cable to connect Craft port to serial
port of laptop computer.
Serial Communication
Establish serial communication with TP5000 using
terminal emulation:

All Programs>Accessories>Communication>
HyperTerminal

COM1 port: 8 data bits, 1 stop bit, no parity, 57,600
baud rate, no flow control
Serial Communication
Establish serial communication with TP500
using terminal emulation

All Programs>Accessories>Communication>
HyperTerminal

COM1 port: 8 data bits, 1 stop bit, no parity,
57,600 baud rate, no flow control
Log on to TimeProvider 5000

User: admin

Password: symmadmin**
Log on to TimeProvider 500

User: admin

Password: symmadmin**