Symmetricom SDU-2000, User Manual

Page: 314 / 470

TL1 Command Interface
314 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
Other TL1 Commands
Table B-7 summarizes the TL1 commands for activating (enabling), disconnecting
(disabling), removing or restarting modules, and for logging in or out of the
SSU-2000.,
Table B-7. Other TL1 Commands
Commands Descriptions
ACT-MODULE:[tid]:aid:ctag;
Valid aid codes:
ScAy
This command activates (enables) a module (not a
specific port.
ACT-USER:[tid]:uid:ctag::pwd;
Valid aid codes: none, requires user name instead.
This command logs in the username
uid
with
password
pwd
.
CANC-USER:[tid]::ctag;
Valid aid code: None
This command logs off the TL1 user and returns to
security level 0.
DISC-MODULE:[tid]:aid:ctag;
Valid aid code;
SxAy
This command disconnects (disables) a module (not a
specific port).
EXIT:[tid]::ctag;
Valid aid code: None
This command logs off the user and returns an
EIA-232 port to ASCII mode or disconnects an
Ethernet session to end TL1 communication.
RMV-MODULE:[tid]:aid”ctag;
Valid aid code:
SxAy
This command removes module configuration
information from the database of the SSU-2000.
RST-MODULE:[tid]:aid:ctag;
Valid aid code:
SxAy
This command restarts (reboots) the specified
module.
RST-CLOCK:[tid]:aid:ctag;
Valid aid codes:
S1A1
,
S1A12
This command resets the specified clock module via
hardware. This reset is more drastic than the restart in
that it does not give the clock time to switch to the
secondary clock if it was the primary clock.